BV200 7-7 Software Downloads

Installation of downloads

Once you have downloaded the relevant file, extract the contents - the downloads are always compressed (or ZIPed) files.  Run the extracted contents on the Benson PC. In most cases it will show a installation dialogue and ask you to confirm the installation, using NEXT buttons, etc.  If you have any queries about what the software does or the changes it will make, please contact the Benson support desk.
Please advise Benson support when you have changed any software on your site. 

 

 

File (click to download) Description
7-7m

Barcode for LOW, HIGH, CHECK changed to identify when used for calibration or as a control

 

List of changes to 7-7 software

 
File (click to download) Description
Please contact us if you need this The latest full install of 7-7 software is 7-7L
 

 

File (click to download) Description
Cleaning Cycles 27 3 2014

Sets the cleaning cycles to the latest release.

Download the file, extract the program then double-click it to install the routines.

 

This sections contains programs not normally required. As a general rule, do not download and install a program unless instructed by the Benson Support team.

File (click to download) Description
Get_Suppport_Files Utility to collect site data to pass to support team.
7-zip Utility Installs utility to allow Get_Support_Files to work
Set Barcode Labels Installs utility to allow site to change barcode label types - USE ONLY if directed by support
 

The following are the correct versions of Approved Software. If in doubt please contact the Support desk

  • Program = BV200_7-7m
  • Help file = BV200_doc-7-7f.chm

Newest full install pack = 7-7L

List of changes to 7-7 software